Notice: This No-glue film is only for smooth glass.Can not fit to frosted glass or art glass.
Installation
Step 1.Measure windows and trim film;
Step 2.Clean glass, then wet glass with soapy water(or just clear water also work well);
Step 3.Affix taps on both sides to remove the transparent backing film.( which is a kind of clear vinyl, please MAKE SURE remove it before you apply the window film to glass);
Step 4.Apply to wet glass and smooth with a smooth tool,such as a credit card or a spatula,or hands;
Step 5.Squeegee away water and air bubbles;
Step 6.Cut off the margins.
Q&A
Q1: Why my film do not stay.
A: Have not wet the window with water, or have not remove the transparent backing film.
S: Remove the transparent backing film, and then wet the window with soapy water.
Q2: I have removed the back film and wet the widow, why still can not stay.
A: You apply the wrong side.The film is divided into two layers, one side is smooth, and the other side is rough.
S: Tear it off and retry another side to paste again.
Q3: There are a large number of small bubbles.
A: Too less water.
S: Tear it down, spray a lot of water and paste it again.
Tips for Installation:
1.A clean and smooth glass surface without any dust, fibre or any kind of texture is needed.
2.The transparent back cover must be peeled off; otherwise, the film will fall off when the water is dry.
3.Do not apply to the window frame.Cut off excessive edges after application if needed.
4.The film may be a little tough and its adhesive effect will be impacted in winter.Solution: use hair dryer or warm water to soft it.( Heat resistance is under 176?H).